← All guidesNETWORK PLANNING

Guest WiFi bandwidth planning for cafés and hotels

Estimate busy-hour internet demand, upload needs and WiFi capacity with an example worksheet for cafés, hotels and public venues.

Count active devices during the busiest hour

Room count and seating capacity are useful starting points, but neither tells you how much internet bandwidth guests will use. Count the devices likely to be active at the same time, then estimate what they will be doing. A connected phone sitting idle and a laptop uploading video create very different demands.

For a hotel, review evening room usage alongside the lobby, restaurant and conference areas. For a café, include the busy work period as well as weekend footfall. Keep business systems such as reception calls, payments and operational uploads in a separate planning budget.

Build a workload worksheet

The following numbers are illustrative planning assumptions, not measured application requirements or a promise of performance. Replace them with your own observations and the requirements of the applications your guests use.

Example busy-hour demand assumptions
ActivityActive devicesAssumed Mbps per device: down / upTotal Mbps: down / up
Browsing and messaging201 / 0.220 / 4
Video viewing105 / 0.250 / 2
Video calls53 / 315 / 15

In this example, 35 active devices produce an estimated 85 Mbps downstream and 21 Mbps upstream. Adding an illustrative 30% planning margin gives 110.5 Mbps down and 27.3 Mbps up, before business traffic. This is an estimate of offered load; it does not determine an ISP plan or an access point count by itself.

Calculate each direction independently: active devices × assumed demand per device, summed across activities. Then include business demand and an explicit allowance for peaks, updates and growth. Check what the service actually delivers during the busy period.

Check upload, delay and wireless capacity

A connection with a large download headline can still struggle with simultaneous calls or uploads. Ask about upstream capacity and observe latency, loss and responsiveness under load. A single speed test near an access point is not a capacity survey.

The WiFi network also needs enough usable radio capacity where guests gather. Walls, interference, channel use, device capabilities, access point placement and wired backhaul affect the result. Adding broadband does not fix every wireless bottleneck.

Cisco Meraki’s high-density design guidance discusses expected client load and capacity planning. Have your SI partner survey the actual venue before choosing access point quantities.

Match policies to the network

Time, speed and device allowances can help distribute a finite connection. Set them around the experience you intend to offer and test the effect on calls, browsing and downloads. A speed allowance is a ceiling, not a reservation or a guaranteed minimum.

WiFiMitra works with supported TP-Link Omada, MikroTik RouterOS HotSpot, Ruijie/Reyee, Ubiquiti UniFi and OpenWrt deployments, alongside WiFiMitra Gateway. The policy controls available depend on the device, firmware and integration mode. See the integration options and confirm enforcement for your installation.

Measure before and after handover

  1. Record busy-hour active devices, upload and download utilisation.
  2. Walk the guest areas and test representative devices.
  3. Run simultaneous workloads rather than isolated speed tests.
  4. Check that guest traffic stays separate from business systems.
  5. Verify configured limits and the support escalation process.
  6. Review the plan after a busy event or a change in occupancy.

If a backup internet link is part of the design, measure its reduced capacity too. Agree which experience is realistic during failover. The cloud and on-site guide explains how hosting and uplink failures differ.